How to apply your graphics is one of our most frequently asked questions. Here are a few steps that should help, along with a helpful video.
1st - Ensure your pods are clean, when we mean clean make sure they are thoroughly cleaned. We advise using break cleaner to get rid of any dirt or adhesive from your previous graphics.
2nd - Using a heat gun, hairdryers will also work, add a little heat to your graphics from approximately 30cm away. This will make the graphics slightly more malluable, and easier to apply.
3rd - Line up your graphics and slowly using a squeegee press your graphics down into place, moving any air bubbles away to the side as you go.
4th - Finally go around the edges of your graphics with the heat gun to seal your graphics to the edges of the pods.
If anything above isn't clear this video should also help. We are also very happy to further advice if you contact us.
Comments
0 comments
Please sign in to leave a comment.